Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Nov 2012
    Location
    Iowa
    Posts
    50
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Congratulations
    0
    Congratulated 0 Times in 0 Posts

    Removing epoxy from metal.

    Wondering if anybody knows how to remove an epoxy from a parkerized metal finish?

    Removed a Lyman 48 sight from a 1903 springfield last night and it appears to have an epoxy based 'pad' underneath.

    Would like to remove the epoxy and fill the holes with plug screws.

  2. #2
    Senior Member
    Join Date
    Jun 2011
    Location
    Dolores, Colorado
    Posts
    2,479
    Thanks
    116
    Thanked 375 Times in 288 Posts
    Congratulations
    4
    Congratulated 1 Time in 1 Post
    I would probably not use any of the chemical based removers, as they probably would attack the blueing on the metal too. You might try an auto body shop that specializes in Corvettes. They use a baking soda based blast that will take paint off but not hurt the fiberglass. Worth a try.
    Colorado Cowboy
    Cowboy Action Shooter; Endowment Life Member-NRA
    The Original Rocket Scientist-Retired
    "My Father always considered a walk in the mountains as the equivalent of church going."
    Aldous Huxley

  3. #3
    Senior Member
    Join Date
    Jun 2011
    Location
    Peoples Republik of Kalifornia
    Posts
    356
    Thanks
    18
    Thanked 52 Times in 40 Posts
    Congratulations
    1
    Congratulated 0 Times in 0 Posts
    I would try heating it a little bit with a small torch. You also might be able to freeze it, and knock it off with a plastic straight edge. Neither of these should hurt the Parkerizing, as it is pretty tough. You may have to refresh the threads in the holes after removing the pad to get the epoxy out of them.
    Patron Life Member, NRA; Life Member RMEF, SCI, NAHHC, NSRPA

 

 

Similar Threads

  1. Sheet metal worker
    By tinman in forum New Members Introduction
    Replies: 12
    Last Post: 02-20-2014, 03:22 PM
  2. Removing old velvet?
    By sjsmallfield in forum Back at the Tailgate
    Replies: 0
    Last Post: 01-25-2013, 07:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •